Skip to content

Try X-PHY Deepfake Detector Free for 30 Days

IP68 / IP69K Rated

Sealed Against Water, Dust & the Elements

X-PHY ToughX carries full IP68 and IP69K ratings — completely sealed against dust ingress and submersion in water up to 1.5 metres. In the field, nature doesn't care about your equipment. ToughX does.

IP68

Dust & Water Rating

Submersion up to 1.5m for 30 minutes

IP69K

High-Pressure Wash

Resistant to high-temp, high-pressure water jets

6/6

Dust Ingress Rating

Completely dust-tight — zero particle ingress

Industry Challenges

How Water, Dust & Humidity Destroy Standard Storage

Standard storage media is built for clean, dry environments. The moment it's exposed to moisture, fine particulates, or high-pressure wash-downs, catastrophic and irreversible data loss is almost certain — with no warning and no recovery.

Water Ingress & Short-Circuit Failure

A single drop of water reaching the controller or flash cells of a standard SSD causes an immediate short-circuit. Rain, condensation from temperature changes, or accidental submersion are all it takes to permanently destroy data with no recovery possible — even by forensic specialists.

Dust & Particulate Contamination

Fine dust, sand, and metallic particles from construction sites, mining operations, and desert environments infiltrate connector ports and card slots. Abrasive particles scratch contact surfaces, corrupt read/write operations, and accelerate wear — causing progressive data loss and premature device failure.

Humidity & Condensation Corrosion

High-humidity tropical environments, marine deployments, and cold-to-warm transitions cause condensation to form inside unsealed storage. Over time, moisture oxidises contact pads and corrodes solder joints — causing silent, cumulative degradation that leads to sudden total failure.

The Solution

X-PHY ToughX: Sealed From the Outside. Secured From Within.

IP68 and IP69K ingress protection combined with hardware-level AI security — so your data is shielded from both the physical environment and digital threats, simultaneously.

IP68 fully sealed waterproof enclosure

IP68 Full Submersion Seal

ToughX is hermetically sealed to IP68 — tested to survive continuous submersion at 1.5 metres depth for 30 minutes. Every port, seam, and contact interface is sealed against liquid ingress, making it suitable for marine, waterway, and wet-environment deployments.

Industrial environment dust and particulate protection

Complete Dust-Tight Enclosure

A 6/6 dust ingress rating means zero particles enter the device under any conditions. Mining sites, desert operations, construction environments, and volcanic ash zones — ToughX keeps contaminants out completely, preserving contact integrity and long-term reliability.

IP69K high pressure washdown resistance

IP69K High-Pressure Washdown

Food processing, pharmaceutical manufacturing, and defence vehicle maintenance require regular high-temperature, high-pressure washdowns. ToughX's IP69K rating ensures it survives cleaning protocols that would instantly destroy standard storage — in place, without removal.

Water Protection

IP68

1.5m Submersion / 30 Min

Pressure Wash Rating

IP69K

High-Temp High-Pressure Jets

Dust Ingress

Zero

Completely Dust-Tight

Technical Superiority

Protection That Goes
Beyond the Enclosure

Conformal Coating on Every PCB

Even behind the IP-rated seal, every ToughX PCB is coated with industrial-grade conformal coating as a second line of defence. If the outer seal is ever compromised, moisture still cannot reach the flash cells or the AI security controller.

Security Intact After Submersion

IP protection and hardware security work in parallel — not sequentially. After a submersion or washdown event, the AI engine and AES-256 encryption resume normal operation immediately. Physical exposure never disables or bypasses the security layer.

Same Form Factor, No Bulk

IP68/IP69K protection is engineered into the standard microSD, SD, and SSD form factors — no external waterproof cases or carriers needed. Fits your existing devices directly, with full environmental protection built in from day one.

Ingress Test: Complete
IP68 Submersion 1.5m depth · 30 minutes
PASSED
IP69K Pressure Wash 80°C · 100 bar · all angles
PASSED
Dust Ingress 6/6 8hr particle chamber test
ZERO INGRESS
Security Post-Submersion AES-256 + AI engine status
ACTIVE
SEAL_INTEGRITY VERIFIED
DUST_INGRESS NONE
AES_256_ENGINE ACTIVE
Marine underwater deployment scenario

Use Case Scenario

Naval Dive Team — Underwater Reconnaissance Recording

A naval dive team deploys underwater camera systems for hull inspection and reconnaissance at up to 1.5 metres depth. With ToughX microSD cards inside every camera, footage is recorded, hardware-encrypted, and fully protected from water ingress — the cards are then washed down with high-pressure salt-water removal equipment post-mission without any damage or data loss.

IP68 seal survives full 1.5m submersion throughout dive operation
IP69K withstands post-mission high-pressure saltwater washdown — no removal required
AES-256 encryption active throughout — footage unreadable if camera is lost or seized
Drop-in microSD — fits existing underwater camera hardware with no modifications